After my success with my first McPattern, how could I stop myself from making another? I wanted to make a big circle tank dress. I started off similar to my tank McPattern. It took a bit to figure out how tight I wanted the dress to my neck and how wide to make the straps. I did the same arc to figure out the curve on the bottom of the dress.
I sewed up the neck and shoulders of the dress first. Immediately I knew I was wrong. The straps were much farther from my neck and the neck scooped to low. I pulled the straps up and pinned them up to where the neckline hit my neck. I used chalk to mark a new line from the outer strap width down into the arm.
After my adjustments, I finished the neckline, arms and sides. It fit so much better! The problem I had now was the extra length I pulled up to move up the neckline made the dress short! Too short!
To remedy this issue, I picked up lace to trim the edge. That did it! It was light enough to keep the float of the rest of the fabric. I sergered the lace to the bottom and topstitched the edge for a clean finish.
This is ridiculously comfortable and surprisingly flattering. I’ve realized that anything with a lot of fabric at the bottom needs to be balanced with a more fitted top otherwise I end up looking like a potato.
I made another McPattern tank. This time in a knit! This was the last little bits of my $5 for 5 yds of grey fabric from Walmart. I made a maxi, dress and tank. There’s a few small pieces left that I would need to mix with something else to make anything. Talk about a deal!
I did topstitch both sides of the straps which I didn’t on the others. I felt that if I didn’t, the strap wouldn’t stay nice and flat.
I’ve had this garment of the year long #sewmystyle project done for over a month. I mistakenly made it last month thinking it was May’s project but that was the doomed Pocket Skirt by CaliFaye. This month’s make is way better! It’s the Briar Sweater & Tee by Megan Nielsen. You may have seen that I wore this shirt twice during #mmm17. It’s pretty awesome!
I bought an fantastic rayon knit from Girl Charlee. It’s two shades of blue; electric and navy. It’s soft and really light. Perfect for a summer tee. I chose the full length shirt over the cropped version. As I’ve said many times before, I’m not a cropped kind of girl but I was concerned about the length on the tail of the full length version. I like a good butt flap but an extreme tail might not be cute.
The shirt is super fast and easy. Fast to cut out and just as fast to stitch. All done in one sitting. I normally don’t do that. I have to think different aspects through before I continue on. Nothing to think through. It’s a t-shirt! Front, back and sleeves. Simplicity at its finest. Check out that stripe matching!
I did have a mishap. I snipped the sleeve! I was trimming out extra fabric on the sleeve hem. The fabric is so light that I didn’t realize I had more than a single layer and SNIP! Crap! I tried to fix it by sewing the little flap I had dangling to cover the hole. Kind of healing itself. That did not wash well at all. I used a bit of cotton fabric the same navy color and put behind the hole and stitched around it. I think this will work so much better.
Nothing else to really say about this one. I enjoy wearing it. The butt flap is a little much. It gets caught on my booty. I would like to try out the cropped version in a sweater. It would look cute for layering.That’s all folks! Have you made the Briar tee? What are your thoughts?